Product Categories
Contact Us

Chongqing Bishan Jiecheng Plastic Co., Ltd.

Add:Shiyang 3rd Road, Qinggang Street,Bishan District,Chongqing,China

E-mail:sales@cqjiecheng.com

Office:+86-23-41802788

Fax:+86-23-41801788


News

Electric Trimming Machine For EPE Foam Sheet Or Film To Keep The Machine Smooth, Not Tilted

Electric Trimming Machine for EPE Foam Sheet or Filmmostly used for wood chamfering, metal trim, strip edging and other motor-type activities of the strong trimming equipment. Also known as chamfering machine.

Electric Trimming Machine for EPE Foam Sheet or Filmis to use the knife to the edge of the board, you can according to the shape of the edge of the wood will be the edge of the corresponding shape, usually used as a right angle into a rounded round edge, also used for proper polishing operation of wood. Also widely used in construction beams, plates, columns, walls and other reinforcement, decoration, wall installation, bracket, railings, billboards, air conditioning outdoor unit, rail, satellite receiver elevator, steel plant

The trimmer is generally operated in one hand, but in order to maintain stability and balance, the other hand can be used to assist.

Operation, first grasp the Electric Trimming Machine for EPE Foam Sheet or Film(note the blade to avoid injury), and then open the Electric Trimming Machine for EPE Foam Sheet or Filmswitch. Beginners have just started operation,

Do not start the machine just when the vibration and sound scared, just start the machine operation when there is a certain vibration, we must hold the machine, do not let go, otherwise it will be dangerous.

After the start of the trimmer (be careful not to block the inlet and outlet, pay attention to the inlet do not inhale the sawdust), the machine will quickly reach the normal speed, and then you can insert the cutter into the workpiece. If the trimming operations, then the base of the next work close to the ground, and then slowly to the cutter against the work, this time must hold the machine, so as not to rebound.

After the cutter is pressed into the workpiece, it is possible to push the milling. The speed of the push is different depending on the type of work, the depth of the milling, the level of the cutter.

If you can not move the feeling, or the motor sound weight, you need to slow down the speed. In the process of advancing, to keep the Electric Trimming Machine for EPE Foam Sheet or Filmsmooth, not tilted, otherwise the milling will not be vertical.

After the milling operation is completed, the trimmer can be lifted vertically so that the milling cutter leaves the workpiece. If you do not lift the Electric Trimming Machine for EPE Foam Sheet or Filmvertically, there is a danger of interrupting the cutter or breaking the workpiece. If the Electric Trimming Machine for EPE Foam Sheet or Filmoperation, or the use of T-shaped ditch knife, flat feather knife, should first push the right side of the cutter to leave the workpiece, and then lift the trimmer.

Electric Trimming Machine for EPE Foam Sheet or Filmlift, you can turn off the trimmer switch, and then the Electric Trimming Machine for EPE Foam Sheet or Filmsquare on the table, milling tip must be forward, it will not hurt themselves. If you want to re-use, it is best to unplug the plug, clean up the machine.